Netcomm N300 Bedienungsanleitung PDF herunterladen (Seite 57)

YML9WMAXXN ADSL2+ Wireless N300 Modem Router with VoIP User Guide

www.netcomm.com.au 57

NetComm Gateway

Series - ADSL2+ Wireless N300 Modem Router with VoIP

Option Description

Log Indicates whether the system is currently recording events. The user can enable or disable event

logging. By default, it is disabled. To enable it, tick Enable and then Apply button.

Log level Allows you to congure the event level and lter out unwanted events below this level. The events

ranging from the highest critical level “Emergency” down to this congured level will be recorded to

the log buffer on the device SDRAM. When the log buffer is full, the newer event will wrap up to the

top of the log buffer and overwrite the old event. By default, the log level is “Debugging,” which is

the lowest critical level. The following log levels are

• Emergency = system is unusable

• Alert = action must be taken immediately

• Critical = critical conditions

• Error = Error conditions

• Warning = normal but signicant condition

• Notice= normal but insignicant condition

• Informational= provides information for reference

• Debugging = debug-level messages

Emergency is the most serious event level, whereas Debugging is the least important. For instance,

if the log level is set to Debugging, all the events from the lowest Debugging level to the most critical

level Emergency level will be recorded. If the log level is set to Error, only Error and the level above

will be logged.

Display Level Allows the user to select the logged events and displays on the View System Log screen for events

of this level and above to the highest Emergency level.

Mode Allows you to specify whether events should be stored in the local memory, or be sent to a remote

syslog server or both simultaneously.

If remote mode is selected, view system log will not be able to display events saved in the remote

syslog server.

When either Remote mode or Both mode is congured, the WEB UI will prompt the user to enter the

Server IP address and Server UDP port.

3: Click View System Log. The results are displayed as follows.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 63 64 65

Keine Kommentare

Netcomm N300 Bedienungsanleitung Seite 57