Netcomm N300 Bedienungsanleitung PDF herunterladen (Seite 9)

YML9WMAXXN ADSL2+ Wireless N300 Modem Router with VoIP User Guide

www.netcomm.com.au 9

NetComm Gateway

Series - ADSL2+ Wireless N300 Modem Router with VoIP

Installation

2.1 Hardware Installation

Follow the instructions below to complete the hardware installation.

1 or 2 Analogue/

Cordless Telephones

Computers connected

via Ethernet

Telephone

Socket

Laptop Computer

connected wirelessly

Phone

ADSL/Modem

Splitter

Connection to ADSL port

Connect to an ADSL2/2+ service with this RJ11 Port. This device contains a micro lter which removes the analog phone signal. If you

wish, you can connect a regular telephone to the same line by using a POTS splitter.

Connection to LAN ports

To connect to a hub or PC, use RJ45 Ethernet cable. You can connect the router to four LAN devices. The ports are auto-sensing MDI/X

and either straight-through cable or crossover cable can be used.

Connection to Phone ports

Connect up tp two standard analogue phones with an RJ11 cable to utilise a VoIP service

Connection to Power

Connect the power jack to the shipped power cord. Attach the power adapter to the wall outlet or other AC source. After powering

on, the router will perform a self-test. Wait a few moments and the router will be ready to operate.

Caution 1: If the router fails to power up, or if it malfunctions, rst verify that the power supply is connected correctly. Then power it on again. If the problem persists, contact our

technical support engineers.

Caution 2: Before servicing or disassembling this equipment always disconnect all power cords and telephone lines from the wall outlet.

Reset Button

In the back panel, there is a reset button. Restore the default parameters of the device by holding down this button until the front panel LED

indicators start blinking simultaneously (about 10 seconds). If held down longer, the device may go into a rmware update state (CFE boot

mode). The user can then update the device from any web browser using the default IP address (http://192.168.1.1) without login.

2.2 Conguring your Computer

PC Network Adapter setup (Windows XP)

Set your network adapter to obtain an IP Address automaticly (See section on PC Network Adapter setup in this manual for details)

• Click on [Start Menu] > select [Control panel] > select [Network Connections]

• Select [Local Area Connection]) icon > select [properties]

• Select [Internet Protocol (TCP/IP)] > Click [Properties]

• Select the [General] tab

• Please select both

- Obtain an IP address automatically

- Obtain DNS server address automatically

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 64 65

Kommentare zu diesen Handbüchern

Keine Kommentare

Netcomm N300 Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Netcomm N300