Netcomm N300 Bedienungsanleitung PDF herunterladen (Seite 11)

YML9WMAXXN ADSL2+ Wireless N300 Modem Router with VoIP User Guide

www.netcomm.com.au 11

NetComm Gateway

Series - ADSL2+ Wireless N300 Modem Router with VoIP

Web User Interface

This section describes the setup procedure to access the web user interface.

3.1 Login Procedure

Follow these steps to login to the web user interface.

1: Open an Internet browser (e.g. Microsoft Internet Explorer) and enter the default IP address for the router in the URL address eld at

top. For example, if the IP address is 192.168.1.1, enter “http://192.168.1.1”.

2: Next, you will be prompted to enter your user name and password. Enter admin as the user name and admin as the password,

and then click OK. These values can be changed later (see section 8.5.3).

3: After successfully logging in, you will reach the Quick Setup menu.

3.2 Default Settings

The following list shows the factory default settings for this router.

• LAN port IP address: 192.168.1.1

• Local administrator account name: admin

• Local administrator account password: admin

• Local non-administrator account name: user

• Local non-administrator account password: user

• Remote WAN access: disabled (except for ICMP)

• Remote WAN access account name: support

• Remote WAN access account password: support

• NAT and rewall: Disabled for MER, IPoA and Bridge modes Enabled for PPPoE and PPPoA modes

• DHCP server on LAN interface: enabled

• WAN IP address: none

• Wireless access: enabled

• SSID: Netcomm Wireless

• Wireless authentication: enabled Password a1b2c3d4e5

• Annex A enabled / Annex M disabled

This router supports the following connection types.

• PPP over Ethernet (PPPoE)

• PPP over ATM (PPPoA)

• MAC Encapsulated Routing (MER)

• IP over ATM (IPoA)

• Bridging

Technical Note:

During power on, the device initializes all settings to default values. It will then read the conguration prole from the permanent storage section of ash memory. The default

attributes are overwritten when identical attributes with different values are congured. The conguration prole in permanent storage can be created via the web user interface

or telnet user interface, or other management protocols. The factory default conguration can be restored either by pushing the reset button for more than ve seconds until the

power indicates LED blinking or by clicking the Restore Default Conguration option in the Restore Default screen, section 8.1.3.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 64 65

Kommentare zu diesen Handbüchern

Keine Kommentare

Netcomm N300 Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Netcomm N300